Renkforce Joystick 1359969 Operating Instructions Manual page 41

Playing a program
• Select the desired program with the BANK buttons (9).
• Press the AUTO/DEL button (7) so that the AUTO LED lights up.
• The programme is played.
• Set the programme speed with the SPEED fader (17).
• Set the cross-fading speed with the SPEED fader (16).
SPEED = Time during which the programme remains in one step (then it will jump to the next step).
FADE TIME = Time during which the programme switches from one step to the next (duration of
the transfer from one step to the next step).
In practice, it has proven helpful to first set the fader SPEED (17) and then achieve a flowing
transfer with the fader FADE TIME (16).
If FADE TIME is higher than the SPEED-setting, the light effect cannot move to the programmed
end positions anymore.
• The programme speed SPEED can also be set through the TAP DISPLAY (10) button. Press it twice. The
interval between the two times corresponds to the programme speed SPEED.
• To stop a running programme, push the PROGRAM/PAUSE button (3). The scene sequence is stopped.
• Press the button PROGRAM/PAUSE button (3) again to reactivate the programme.
• To darken the effect light without interrupting the programme sequence, push the BLACKOUT (11) button.
Pressing this button again switches the effect light on again.
Checking a program
• Press and hold the PROGRAM/PAUSE button (3) until the respective LED flashes.
• Push the button BLACKOUT (11), to deactivate the blackout mode and visually check the light scene.
• Select the desired programme with the BANK buttons (9).
• Press the SCENES (2) buttons to check the different scenes.
You can also view the individual scenes as they have been programmed with this function.
Changing single scenes in a program
Often, separate scenes must be changed. You do not have to change the complete programme, but may
also change single scenes.
• Press and hold the PROGRAM/PAUSE button (3) until the respective LED flashes.
• Push the button BLACKOUT (11), to deactivate the blackout mode and visually check the light scene.
• Select the desired programme with the BANK buttons (9).
• Press the SCENES (2) button for the scene to be changed.
• Select the desired light effect to be changed with the respective SCANNERS (1) button.
• Change the selected scene with the channel faders (18) and the joystick PAN/TILT (13) until it corre-
sponds to your requirements.
41