C) Programming Programes (Banks) - Renkforce Joystick 1359969 Operating Instructions Manual

c) Programming programes (BANKs)

A program (BANK) is a sequence of light scenes (SCENES) to be played in sequence.
This DMX controller can save up to 30 programes (BANKS) with up to 8 scenes (SCENES) each.
Saving a programme
• Press and hold the PROGRAM/PAUSE button (3) until the respective LED flashes.
• Push the button BLACKOUT (11), to deactivate the blackout mode and visually set the light scene.
• Select the desired light effect with the respective SCANNERS (1) button.
• Set the desired DMX channel values via the respective channel faders (18) and the joystick
PAN/TILT (13).
• Select the next light effect with the respective SCANNERS (1) button as described above.
• Set the channel values for all light effects that are to be saved in this scene as described above.
This is the first light scene with which programming starts later.
• Press the MIDI/REC button (5).
• Select the desired programme number for the programme to be saved as with BANK buttons (9). The
programme number is indicated on the display (6).
• Press the respective SCENES (2) button for the first scene to be saved as. The scene number is indicated
on the display (6).
• All LEDs will light up briefly, and the first scene is saved.
• Repeat the scene storage procedure described above until all desired scenes for the programme have
been saved. You can save up to 8 scenes per programme.
• Press and hold the PROGRAM/PAUSE button (3) until the respective LED goes out.
• The DMX controller is now in blackout mode again.
40