Installing The Antennas (Optional) - Asus PE200S Series User Manual

3.10 Installing the antennas (optional)

You may install antennas to the four (4) antenna holes located on the front
and rear panels. The installed antennas can be connected to a WWAN card
installed in the Mini PCIe slot, or to a wireless card installed in the M.2 Wi-Fi
slot.
1. Remove the rubber caps from the antenna hole.
2. Prepare the RF connector and cable.
3. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards.
4. Insert the bundled O-ring to the antenna jack, then secure the antenna
jack using bundled hex screw.
5. Connect the other end of the RF connector and cable to your wireless
card or WWAN card.
6. Repeat steps 1 to 5 to install additional antennas.
PE200S Series 55