Auto Standby; Undok - Everything In The Palm Of Your Hand; First-Time Setup Of The Device With Undok; Procedure For Ios Users - Hama DIR3200SBT Operating Instructions Manual

To activate the automatic setting (sensor), proceed
as follows:
• Press [ ] (7) and navigate to the "Settings" menu item.
• Select "Backlight" and confirm by pressing [POWER/
VOLUME/ENTER/NAVIGATE] (11).
• Select the "Automatic" setting to activate the brightness
sensor.
Note
• The brightness sensor is located on the top of the radio.
• Take care not to cover the brightness sensor. Automatic
adjustment of the brightness setting is otherwise not
possible and the display will remain permanently dark.
• Disable the brightness sensor by placing the radio on
a shelf to avoid a permanently dark display.

16.9 Auto standby

Note
• For reasons of environmental protection and to
save valuable raw materials, the radio automatically
switches to standby mode after 15 minutes as soon
as the playback has been switched to a very low
volume or if the radio has been muted.
To enable or disable this function, proceed as follows:
[ ]
System settings

Auto standby
25
17. UNDOK – Everything in the palm of your hand
The UNDOK app, developed by Frontier Silicon, gives you
full control of radios and speakers from your smartphone.
Whether you are setting up the device for the first time,
specifying settings for the equaliser or managing your
favourite stations – UNDOK lets you access all the features
from your smartphone or tablet, thereby offering you
greater convenience.

17.1 First-time setup of the device with UNDOK

The first time you switch on an UNDOK-enabled product
from Hama, or when you have set it to the factory settings,
it creates a micro access point – a separate Wi-Fi network
that you can connect to with your tablet or smartphone.

17.1.1 Procedure for iOS users

• Open the UNDOK app on your iPhone or iPad
• Tap the Set up audio system menu item
• Make sure that the radio or speaker is in SETUP mode.
Set the product to the factory settings, if necessary.
Confirm the query with Next
• The UNDOK app now prompts you to connect to the
product's Wi-Fi network using the iPhone/iPad settings –
to do so, switch to the system settings on your iPhone
and select the Wi-Fi network (for example, Setup Hama
DIR3120LED). Then return to UNDOK and tap Next
• Now choose a name for the radio (for example,
Office DIR3120) and confirm your entry with Next
• This takes you to the date and time settings – here you
set the time format, time source and time zone.
• The various network configuration options are then offered
to you (where applicable, Wi-Fi, WPS and Ethernet). Tap
the desired method; UNDOK switches to the next window