Repairs
(cont.)
5. Remove two screws C from the
plate heat exchanger and remove
plate heat exchanger D with gas-
kets.
Note
During removal, small amounts of
water may trickle out and escape
from the plate heat exchanger.
6. Check the DHW side for scaling and
if required clean or replace the plate
heat exchanger.
Checking the fuse
1. Switch the power OFF.
2. Open control unit casing (see
page 14).
7. Check the heating water side for con-
tamination and if required clean or
replace the plate heat exchanger.
8. Install in reverse order with new gas-
kets.
Note
Ensure that fixing holes and gaskets
are aligned. Install the plate heat
exchanger with the correct orienta-
tion.
F4
3. Check fuse F4.
Troubleshooting
51