Power Case Upside; How To Use The Power Switch - Ignition Airbase 850 MK2 User Manual

3.2. Power Case upside

6. 10 A fuse and fuse holder with VDE
certificate AC 100~240V
7. DMX output for connecting the
inserted device
8. DMX input for connecting the
inserted device
9. SCHUKO-socket max. 10 A

3.3. How to use the Power Switch

The power switch has 3 Steps. Here follows the explanation for it:
Step 1: Normal working conditions. That means the air pressure sensor is switched on and the
power plug inside is switched on according to the pressure. That's in this state to
prevent the running moving head from twisting the rain cab if the air pressure is not
strong enough. Then the air pressure sensor shuts down the power plug inside.
Step 2: Installation Mode
In this Mode the Air pressure sensor is switched off and the Power plug is switched
On. That's in this state that you can adjust the settings and addressing of the fixture
without the rain cab.
Step 3: Hard Reset / OFF
This mode shuts down the internal Power Plug, that you can do a hard reset for the
moving light without removing the cab.
NOTE: The AIR BASE 850 MK2 contains an air pressure sensor. Only if the total air pressure is
built up in the air cone, the power plug will give power to the items inside. Do not be
surprised if only then there's electricity from the socket-outlet. That's for safety
reasons so a moving head will not rotate uncontrolled and entangles itself in the foil.
13 / 15
A I R B A S E 8 5 0 M K 2