Operation Of The Comfort Leds - Abus FUSG50101 Installation Instructions And User Manual

Functions, jumpers and displays
BAT A/B
Insert the battery connectors (taking care to observe correct polarity) until the connector is
locked in place.
Important
Insert the wires of the battery connector cable into the wire guides provided. Otherwise, the
wires may be crushed.

Operation of the comfort LEDs

In normal operation, the comfort LEDs flash alternately if the sounder is connected to the power
supply to visually display that the system is operational.
When installer mode is activated on the alarm panel, the two comfort LEDs are continuously on for
several minutes. The comfort LEDs are also permanently on during the silent start phase between
connection of the batteries and up to ten seconds after closing the cover.
Note:
Software version display
The software version of the sounder is indicated by the comfort LEDs immediately after the power
supply is connected.
The red comfort LED indicates the major software version.
The left comfort LED indicates the minor software version.
The red comfort LED indicates the design (2 = wireless sounder).
Example:
Left LED flashes eight times
Software version "1.8.2"
Note:
Flashing or non-flashing of the comfort LEDs during normal operation.
Connect the batteries with the cover open.
The software version will be displayed, as described above.
The sounder switches to the silent start-up phase. Both comfort LEDs light up red.
Flip the tampering switch five times, which will turn the flashing on or off.
Their current status is displayed as shown here:
BOTH LEDs on:
ONE LED (right LED) on:
The installer mode display and the software display will not be affected by this.
34 | EN
Right LED flashes once
Right LED flashes twice
Comfort LEDs flash during normal operation
Comfort LEDs do not flash during normal
operation