Table of Contents
Advertisement
3.
Unpack the transportation package from the pendant mount anesthesia machine.
4.
If present, remove any extra load attached to the Carestation 650c top shelf and tabletop; for example, monitors,
accessories, etc.
5.
Loosen the screws of the two tilt blocks (located on the lower rear panel of anesthesia machine). Slide the tilt blocks
to the far left and far right positions.
6.
Turn the tilt adjustment screw (C) counterclockwise till the screw bolt end recedes into the hole.
Datex-Ohmeda, Inc.
3030 Ohmeda Drive
PO Box 7550
Madison, WI 53707-7550, USA
C
This document contains confidential information or proprietary information of General Electric Company or its af-
filiates. Neither the document nor the information therein is to be reproduced, distributed, used, or disclosed, either
in whole or in part, except as specifically authorized in writing by a General Electric Company and must be returned
upon request.
Installation Instructions,
For future reference add to your Technical Reference Manual
M1807013 Rev. F
For Field Use
01 15
Page 2 of 6
Advertisement
Table of Contents
Need help?
Do you have a question about the Carestation 650c and is the answer not in the manual?
Questions and answers