Advertisement
Quick Links
BRICK Series
Chassis for KINO/NANO/WAFER SBC
Quick Installation Guide
Version 1.00
Packing List
1 x BRICK series chassis
4 x SBC retention screws (round head, M3*6)
4 x HDD retention screws (pan head, M3*4)
1 x Power button with cable
1 x Power jack with cable (BRICK-NANO and BRICK-WAFER series only)
D-Sub hex-head screws for securing front I/O ports (numbers of screw differ by model)
Advertisement
Related Manuals for IEI Technology BRICK Series
Summary of Contents for IEI Technology BRICK Series
- Page 1 Chassis for KINO/NANO/WAFER SBC Quick Installation Guide Version 1.00 Packing List 1 x BRICK series chassis 4 x SBC retention screws (round head, M3*6) 4 x HDD retention screws (pan head, M3*4) 1 x Power button with cable 1 x Power jack with cable (BRICK-NANO and BRICK-WAFER series only)
-
Page 2: Safety Instructions
Safety Instructions Warning! Read this installation guide before connecting the system to the power source. Warning! To prevent the device from overheating, do not operate it in an area that exceeds the maximum operating temperature described in the user manual came with the SBC. Warning! Ultimate disposal of this product should be handled according to all national laws and regulations. -
Page 3: Installation Procedure
Installation Procedure To install SBC and HDD into the chassis, follow the steps below: For BRICK-KINO Series For BRICK-NANO/WAFER Series Step 1: (Optional) Install a 2.5" HDD Step 1: (Optional) Install a 2.5" HDD inside the bottom panel. Place an HDD inside the top panel. - Page 4 For BRICK-KINO Series For BRICK-NANO/WAFER Series Step 2: Install a KINO SBC. Align the Step 2: Install a NANO/WAFER SBC. screw holes on the SBC with the Align the screw holes on the SBC with standoffs on the bottom panel. Secure the standoffs on the bottom panel.
- Page 5 Step 4: Assemble two side panels. Insert a side panel into the slot of the installed edge bar, and then insert the other side panel into the other edge bar. Both side ends of the side panel should properly align with the side ends of the edge bar. For BRICK-KINO Series For BRICK-NANO/WAFER Series Step 5: Install power button and rear...
- Page 6 Step 6: Connect cables and additional I/O ports. Connect the power button cable, the power LED cable and the power connector cable (BRICK-NANO/WAFER series only) to the corresponding connectors on the SBC (refer to the QIG that came with the SBC for detailed information).
- Page 7 Step 9: Install front panel. The front panel has several knockout holes for connecting additional ports from the SBC. Knock out the holes and install connectors if necessary. Lastly, install the front panel to the chassis with four screws (flat head, M3*6, black).
- Page 8 Headquarters America China IEI Technology USA Corp. 威強電工業電腦股份有限公司 威强电工业电脑 IEI Integration Corp. 138 University Parkway, Pomona, 上海市闵行莘庄工业区申富路...