Download Table of Contents Print this page
DeWalt DC021 Operating Instructions Manual

DeWalt DC021 Operating Instructions Manual

Hide thumbs Also See for DC021:




Table of Contents

Summary of Contents for DeWalt DC021

  • Page 1 DC021 DC022 www.
  • Page 2 Figure 1 DC021 DC022 Figure 2...
  • Page 3 Figure 3 Figure 4 DC022 DC022 Figure 5...
  • Page 4 Figure 6 Figure 7...
  • Page 5: Technical Data

    E N GLIS H HEAVY-DUTY CORDLESS/CORDED WORKLIGHT/1-HOUR CHARGER DC021/DC022 Congratulations! CAUTION: Used without the safety alert symbol indicates a potentially hazardous You have chosen a D WALT tool. Years of situation which, if not avoided, may experience, thorough product development and result in property damage.
  • Page 6: Important Safety Rules

    Important Safety Rules • Vision may be impaired when looking directly into fluorescent light. 1. WARNING! When using the DC021 and • Do not expose light or charger to wet or damp DC022 worklight/chargers, basic precautions areas. Do not expose light or charger to rain or should always be followed, including the snow.
  • Page 7: Residual Risks

    This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk. • The DC021 and DC022 (230 V) worklight/ chargers are designed to operate on 230 Volts, 50 Hz AC (except outlets). The DC022...
  • Page 8 EN GLIS H Additional Safety Instructions for Battery defective Battery Packs Hot\cold pack delay When using the charger, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and personal injury. Read Do not probe with conductive objects. the following safety instructions before attempting to operate this product.
  • Page 9: Package Contents

    • Cut off the plug and dispose of it safely; a plug INTENDED USE with bared copper conductors is dangerous if The DC021 and DC022 worklight/chargers are engaged in a live outlet. designed to use as a light source and to charge •...
  • Page 10: Using An Extension Cable

    DC021 AND DC022 BATTERY TYPE fitted to the sheath of the cable. The DC021 and the DC022 will charge 7.2–18 Volt WALT battery packs and will provide light using Using an extension cable 12–18 Volt D WALT battery packs.
  • Page 11 5. Charge time for D WALT 7.2 –18 V battery not illuminated. packs is approximately one hour. 1. Place the folded DC021/DC022 on a stable, Battery Cap (fi g. 5) level surface so that the charger receptacles are in sight.
  • Page 12: Service Notes

    EN GLIS H 8. Replace the lens cover. Place the rubber gasket CAUTION: Cut hazard. If replacing a in one corner and roll the gasket into place on broken bulb, protect your hands before all four sides of the worklight housing. Ensure attempting to remove the bulb.
  • Page 13: Optional Accessories

    E N GLIS H Optional accessories WARNING: Since accessories, other than those offered by D WALT, have not been tested with this product, use of such accessories with this tool could Rechargeable battery pack be hazardous. To reduce the risk of injury, only D WALT, recommended This long life battery pack must be recharged when...

This manual is also suitable for:


Table of Contents