Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt DCL030-XE
Summary of Contents for DeWalt DCL030-XE
- Page 1 INSTRUCTION MANUAL DCL030-XE, DCL040-XE CORDLESS LED WORKLIGHT...
-
Page 3: Definitions: Safety Guidelines
Distractions can cause you to lose control. Technical Data 2) ELECTRICAL SAFETY DCL030-XE DCL040-XE a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. - Page 4 f) If operating a power tool in a damp location is unavoidable, use a residual c) Disconnect the plug from the power source and/or the battery pack from current device (RCD) protected supply. Use of an RCD reduces the risk of the power tool before making any adjustments, changing accessories, or storing power tools.
-
Page 5: Electrical Safety
Electrical Safety CAUTION: When not in use, place light on its side on a stable surface where it will not cause a tripping or falling hazard. Some products with large battery packs The electric motor has been designed for one voltage range only. Always check that will stand upright on the battery pack but may be easily knocked over. -
Page 6: Important Safety Instructions For All Battery Chargers
• Never force the battery pack into the charger. Do not modify the battery pack • If battery contents come into contact with the skin, immediately wash area with in any way to fit into a non-compatible charger as battery pack may rupture mild soap and water. - Page 7 Charging Procedure (Fig. 1) • Pull by the plug rather than the cord when disconnecting the charger. This will reduce the risk of damage to the electric plug and cord. 1. Plug the charger into an appropriate outlet before inserting the battery pack. •...
-
Page 8: Charge Indicators
Charge Indicators 3. A cold battery pack will charge at about half the rate of a warm battery pack. The battery pack will charge at that slower rate throughout the entire charging cycle This charger is designed to detect certain problems that can arise. Problems are indicated and will not return to maximum charge rate even if the battery pack warms. - Page 9 OPERATION NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be recharged before use. WARNING: To reduce the risk of serious personal injury, turn light off and SAVE THESE INSTRUCTIONS FOR FUTURE USE disconnect tool from power source before making any adjustments or removing/ installing attachments or accessories.
- Page 10 WARNING: Never use solvents or other harsh chemicals for cleaning the CAUTION: Only use the belt hook or the loop (B) for FIG. 5 non-metallic parts of the tool. These chemicals may weaken the plastic materials hanging the LED worklight. The belt hook and loop are not used in these parts.
- Page 12 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (JUN12) Part No. N189896 DCL030-XE, DCL040-XE Copyright © 2011, 2012 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...