Enclosure Installation To Ept650 Tilt Wall Mount - peerless-AV HDS-OWK Series Installation And Assembly Manual

Enclosure Installation to EPT650 Tilt Wall Mount

Open the wireless receiver enclosure (A) and unplug the wireless receiver power cord from the wireless receiver.
8
Remove the wireless receiver and sub panel assembly as shown in fi g. 8.1. Loosely attach the small enclosure
mounting brackets (J) to the wireless receiver enclosure (A) with two 1/4-20 x 1/2 socket head screws (G) and
two 1/4-20 nuts (H) as shown in fi g. 8.2. NOTE: The enclosure mounting bracket can be installed with the inside
notch facing downward if additional side to side adjustment is needed. Position and tighten the four 1/4-20 x 1/2
socket head screws (G) using 4mm allen wrench (L). Press in two plastic plugs (F) into holes shown in fi gure 8.2.
A
SUB PANEL
ASSEMBLY
WIRELESS
RECEIVER
POWER CORD
WIRELESS
RECEIVER
9
Attach the mounting brackets (J), open end of notch facing downward, to the left tilt bracket with two
1/4-20 x 1/2 socket head screws (G) and two 1/4-20 nuts (H) as shown in fi g. 9.1. Adjust the position of the
enclosure (A) to your desired location and tighten the four 1/4-20 x 1/2 socket head screws (G) using 4mm allen
wrench (L).
fi g. 8.1
H
A
fi g. 9.1
F
H
16 of 22
G
INSIDE NOTCH
J
G
LEFT TILT BRACKET
2016-09-07 SHEET #: 180-9091-1
fi g. 8.2