Advertisement
Wireless Receiver Setup
Insert the sub panel assembly into the wireless receiver enclosure (A) above the foam pads as shown. Push
11
the sub panel assembly towards the rear of the until it makes contact with the back wall and the bottom of the
enclosure .
12
Insert an extension cord (not included) through the cord access hole in the bottom of the enclosure as shown. Plug
entension cord into the triple tap grounded outlet.
EXTENSION CORD
CORD ACCESS
HOLE
SUB PANEL
ASSEMBLY
FOAM PADS
19 of 22
A
TRIPLE TAP
GROUNDED OUTLET
2016-09-07 SHEET #: 180-9091-1
Advertisement
