Advertisement
Quick Links
Advertisement
Related Manuals for peerless-AV KIP640-S
Summary of Contents for peerless-AV KIP640-S
- Page 1 2015-04-28 #:150-9052-3 (2017-07-12)
- Page 2 WARNING ENG - Do not begin to install product until you have read and understood the instructions and warnings contained in this user guide. This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is included for wood stud, solid concrete and cinder block installation. Before installing make sure the supporting surface will support the combined load of the equipment and hardware.
- Page 3 Tools Needed for Assembly. ENG To properly tighten screws: Tighten until screw head makes contact, then tighten another 1/2 turn. Do not overtighten screws. +1/2 5/32" (4mm) 3/8" (10mm) 5/16" (8mm) 2015-04-28 #:150-9052-3 (2017-07-12)
- Page 4 Parts (Before beginning, make sure you have all parts shown below). Parts List KIP640 KIP642 KIP643 KIP646 KIP647 KIP640-S KIP642-S KIP643-S KIP646-S KIP647-S Description Part # Part # Part# Part # Part # A kiosk BLK 150-P1706 150-P1707 150-P1658 150-P1702...
-
Page 5: Table Of Contents
A ( 1 ) B (4) C (4) kiosk M5 x 12 mm M5 x 25 mm D (4) E (4) M6 x 12 mm M6 x 25 mm F (4) G (4) M8 x 12 mm M8 x 25 mm J ( 2 ) K ( 1 ) allen... - Page 6 This page intentionally left blank. 2015-04-28 #:150-9052-3 (2017-07-12)
- Page 7 J ( 2 ) 2015-04-28 #:150-9052-3 (2017-07-12)
-
Page 8: A ( 1 )
Concrete/Cinder block. Wood stud wall. WARNING ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8". 3a-1 Use stud finder to locate and mark stud center lines. -
Page 9: M ( 4 )
3a-3 2.5" (64mm) 5/32" 5/32" (4mm) (4mm) Drill mounting holes into supporting surface (2.5" (64 mm) minimum depth required). Mounting hole must center on stud. 3a-4 Level wallplate. Install using wood screws provided. 3/8" (10mm) Maximum 80 in. • lb (9 N.M.). M (4) 2015-04-28 #:150-9052-3... - Page 10 WARNING ENG - When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum compressive strength of 2000 psi. When installing Peerless wall mounts on a cinder block wall, the cinder blocks must meet ASTM C-90 specifications and have a minimum nominal width of 8".
- Page 11 3b-3 Insert anchor flush to concrete. L (4) 3b-4 3/8" Maximum 80 in. • lb (9 N.M.). (10mm) Level wallplate. Install using concrete anchors and wood screws provided. M (4) 2015-04-28 #:150-9052-3 (2017-07-12)
- Page 12 Center adaptor brackets vertically on back of screen. N (2) ENG Use of spacers is optional. H (4) C (4) B (4) D (4) H (4) H (4) I (4) E (4) F (4) G (4) H (4) I (4) I (4) 2015-04-28 #:150-9052-3...
- Page 13 Note: Mounting Arm swings out to access adapter brackets and behind display 2015-04-28 #:150-9052-3 (2017-07-12)
- Page 14 2015-04-28 #:150-9052-3 (2017-07-12)
-
Page 15: J ( 2 )
J ( 2 ) KIP640, KIP640-S, KIP642, KIP642-S, KIP643, KIP643-S, KIP646, KIP646-S, KIP647, KIP647-S, KIP648, KIP648-S, KIP649, KIP649-S, KIP655, KIP655-S 2015-04-28 #:150-9052-3 (2017-07-12) - Page 16 This warranty gives specific legal rights, and you may also have other rights which vary from state to state. Patent Pending Peerless-AV Peerless-AV Europe Peerless-AV de Mexico 2300 White Oak Circle Unit 3 Watford Interchange, Ave de las Industrias 413...