Service - Graco PM5 238511 Instructions And Parts List

Replacing the Battery
WARNING
FIRE AND EXPLOSION HAZARD
Only replace the battery in a
non-hazardous location, away from
flammable fluids or fumes.
You may order battery Part No. 113716 separately.
Battery required to meet safety approvals:
Duracell alkaline MN1604, PC1604
or
Eveready alkaline EN22, 522
CAUTION
Before you replace the battery, press the Manual/
Reset button, which clears the dispensed amount
to zero. This saves everything to memory.
The low-battery and dead-battery displays are
explained in the Troubleshooting chart on page 13.
To change the battery, press the Manual/Reset button,
remove the impact guard (28), remove the battery
cover (2), and put in a new battery.
16 309377

Service

Replacing the Filter
The filter (25) is replaceable. To replace the filter, do
the following:
1. Relieve the pressure.
To reduce the risk of serious injury whenever you
are instructed to relieve pressure, always follow the
Pressure Relief Procedure on page 5.
2. Unscrew the hose from the swivel (3).
3. Remove the o-ring (27), and remove the old filter
(25) from its seat in the swivel (3) with an o-ring
pick.
4. Push the new filter (25) into the swivel (3), and
make sure it is properly seated. Replace the
o-ring (27).
NOTE: Orient the new filter (25) so the concave side
of the screen points downstream, as shown below.
5. Screw the hose back into the swivel (3).
WARNING
3
27
25