Installation - Graco PM5 238511 Instructions And Parts List

Typical Installations
Fig. 1 shows a typical hose reel installation. These
dispense valves can also be installed on a console, as
shown in Fig. 2.
CAUTION
Do not use this dispense valve on non-Graco
consoles. Such use could result in the trigger
becoming inadvertently pressed while the dis-
pense valve is stowed.
H
Fig. 1
KEY DESCRIPTION
H Thermal relief kit (required) Part No. 235998
Install downstream from pump.
J Fluid shut-off valve
K Hose
L Hose reel fluid inlet hose
M Hose reel
N PM5 electronic metered dispense valve
4 309377

Installation

The typical installation shown in Fig. 1 is only a guide.
The components shown are typical; however, it is not a
complete system design. Contact your Graco distribu-
tor for assistance in designing a system to suit your
particular needs.
This dispense valve is not designed for in-line
installation. Do not install with a shut-off valve
on the outlet side of the meter. Such installation
could result in damage to the meter housing
cover.
Mounting Bracket
Mounting bracket 196471 is available for resting a PM5
dispense valve on a console. See Fig. 2.
J
L
Do not obstruct the trigger of this dispense
valve, and do not set the unit down resting on its
trigger, or it might not stop dispensing.
M
mounting bracket
196471
K
N
06174B
Fig. 2
CAUTION
CAUTION
TI0334