Adjusting The Volume - Midland BT2 Manual

Attention: the device search procedure (red and
blue lights flashing) continues for approximately 2
minutes. If no device is found within this interval of
time, the BT2 returns to the Setup mode (red light
permanently on). To start again the search, repeat
the pairing procedure from step 2. To cancel the
pairing procedure (red and blue indicators flashing)
and return to the Setup mode at any time, press
"Intercom" button twice.
Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing
references stored in the BT2 unit (reset operation).
To perform this operation, simultaneously press and hold
down the "Volume +" and "Volume –" buttons for 4 seconds.
The Blue Light will be lit on for 1 sec.
This procedure deletes all the paired Bluetooth devices
stored in the memory and it is therefore possible to start a
new "clean" pairing session.
Exiting from the Setup mode
After you have paired the desired Bluetooth devices, you
must quit the "Setup" mode in order to be able to use your
BT2.
Press and hold the Intercom button (centre button) for 3 sec-
onds. The red indicator switches off and the blue one starts to
flash. You can now use your BT2.
Reconnecting the unit to bluetooth devices
After successfully pairing your devices, you can switch them
off and on without having the repeat the pairing procedure.
If a connection failure occurs between the two devices (for
example because one device is switched off or you are not
within the maximum range), it is not necessary to repeat the
pairing procedure.
Simply switch the device on again or move within the maxi-
mum range. If the connection cannot be re-established auto-
matically, select the device from the "devices menu" of your
Bluetooth device (for example mobile phone, MP3 player,
etc...) and re-enable the connection.

Adjusting the volume

Your Midland BT2 uses AGC technology, which automatically
adjusts the listening volume in relation to background noise.
However, it is also possible to manually adjust the volume by
means of the "Volume+" and "Volume -"buttons.
For example, you can manually adjust the maximum volume in
very noisy environments (for example when travelling at high
speeds), to allow the AGC automatic system to change the vol-
ume and use the manually set volume as maximum setting. This
operation is useful because each type and standard of helmet is
influenced in different ways by wind and background noise.
Using the features of the bluetooth
devices
Using the intercom feature
To use the Intercom feature, be sure both units are turned
on and correctly paired together.
If you have purchased a "single" version, follow the pairing
procedure described in section "Pairing the unit with an-
other BT2 unit" above.
Priority: Intercom communications always have a higher
priority, compared to other communications, with the only ex-
ceptions being Telephone and GPS Sat-Nav. Therefore, the
Intercom feature automatically disables all other communica-
tions.
The Intercom feature is disabled only when an incoming call
or voice communication is received from the GPS Sat-Nav,
and is automatically re-enabled as soon as these communi-
cations end.
Attention: some mobile phone release the line after a few
seconds, which means that the Intercom feature may not
be immediately available.
The Intercom feature can be enabled in two ways:
Manual activation:
› Press "Intercom" button, on one of the two units. Commu-
nication is enabled and remains active until you press the
"Intercom" button again. You will hear 1 audio tone when
the Intercom feature is enabled and 2 audio tones when it
is disabled.
9