Midland BT2 Manual page 36

Pairing another BT2 unit
Reset all paired devices
SPECIAl SETUP CONFIGURATION
3 way conversation always on
Change VOX sensitivity or disable it
Exit SETUP mode
European CE Notice Certification and Safety Approvals Information
This product is CE marked according to the RTTE Directive (99/5/EC) and is free use in all the EU countries.
Users are not permitted to make any changes or modifications to the device.
Modifications which are not expressly approved by the producer invalidate the warranty card.
For further information, please go to our website
www.cte.it
18
While in Setup mode, press the Volume + on one unit (the light will flash Red and
Blue alternately), press the Volume - on the other unit (the light will flash Red and
Blue alternately). On a successful pairing, both light turn to Blue for one second.
While in Setup mode, long press he Volume + and he Volume -. On a successful
reset, the Blue light will turn on for two second.
While in Setup mode, press the Phone and AUX buttons for 3 sec.
Steady Blue for two seconds= activated
Double long flash = deactivated
While in Setup mode, press short the AUX buttons (blue light on).
Now, press "Volume +" or "Volume -"to increase or reduce sensitivity. Press again
the AUX button to confirm the new setting and go back to the SETUP mode (Red
light always on).
Blue light flashing:
Once = VOX disable
Twice = very low sensitivity
3 times = low sensitivity
4 times = medium sensitivity.
5 times = high sensitivity
While in Setup mode, long press the Intercom button. The Red light will turn off and
the Blue light starts flashing.