Safety Notes; Installation - IMG STAGELINE C-RAY/310 Instruction Manual

LINE
OUTPUT
5
FUSE
230 V~/
50 Hz
6
1 2
C-RAY/310
MIC / LINE
INPUT
CLIP
3
LINE
AUX
MIC
GAIN
L
R
MIN
6 7
Active Column Speaker System
The instructions are intended for users with
basic knowledge in audio technology . Please
read the instructions carefully prior to op-
eration and keep them for later reference .
1 Applications
The active 2-way column speaker system
C-RAY/ 310 can be used for various PA ap-
plications . Two amplifiers, each with a rated
power of 250 W for the subwoofer and
100 W for the column speaker, are available .
The audio input can be switched from line
level to microphone level .
2 Overview
1 Button LINE / MIC for the input sensitivity
of the combined jack (6)
line level: disengage the button
microphone level: engage the button
2 Input AUX (3 .5 mm jack, stereo)
11
3 Overload indicator CLIP
4 Power indicator ON
SPEAKER
OUTPUT
5 XLR jack LINE OUTPUT to route the input
signal to another active speaker column,
for example
6 Input via a combined XLR / 6 .3 mm jack
(bal ., mono)
7 Input via RCA jacks
8 Control GAIN to adjust the input sen-
sitivity
12
9 Control SUB to adjust the volume of the
subwoofer
10 Control SPEAKER to adjust the volume
POWER
of the speaker column
11 Connection SPEAKER OUTPUT for the
speaker column
13
12 POWER switch
USE ONLY WITH A 250V FUSE
13 Support for the mains fuse
14
Always replace a blown fuse by one of
the same type!
14 Mains jack for connection to a socket
(230 V/ 50 Hz) by means of the mains
cable provided
ON
4
SUB SPEAKER
MAX MIN MAX MIN MAX
8 9 10

3 Safety Notes

The unit corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The unit is supplied with dan-
gerous mains voltage . Leave
servicing to skilled personnel
only! Inexpert handling may
result in electric shock .
•
The unit is suitable for indoor use only .
Protect it against dripping water, splash
water and high air humidity . The ad-
missible ambient temperature range is
0 – 40 °C .
•
Do not place any vessel with liquid on the
unit, e . g . a drinking glass .
•
Immediately disconnect the mains plug
from the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket, always
seize the plug .
•
For cleaning only use a dry, soft cloth;
never use water or chemicals .
•
No guarantee claims for the unit and no
liability for any resulting personal damage
or material damage will be accepted if the
unit is used for other purposes than orig-
inally intended, if it is not correctly con-
nected or operated, or if it is not repaired
in an expert way .
If the unit is to be put out of oper-
ation definitively, take it to a local
recycling plant for a disposal which
is not harmful to the environment .

4 Installation

1) Place the subwoofer on an even, horizon-
tal surface (floor) .
2) Screw the distance rod provided into the
treaded hole on the upper side of the
subwoofer .
3) Screw the threaded hole of the speaker
column onto the distance rod .
4) Adjust the height of the distance rod in
such a way that the centre of the speaker
column is approximately at ear level of
the audience .
Pull out the telescopic rod to the
height required, put the safety pin
through the rod and then tighten the
locking screw .
.