Operation; Safety Notes - IMG STAGELINE WAVE-12A Instruction Manual

2
SD MODE
4
WAVE-15A
1
2
6
SD MODE
4
6
Active PA Speaker System
These instructions are intended for users with
basic knowledge of audio technology. Please
read the instructions carefully prior to operation
and keep them for later reference.
1 Applications
This speaker system of the WAVE series with
integrated mixing amplifier can be used for
versatile sound applications. Due to its compact
and lightweight design, the speaker system is
ideally suited for mobile applications, for ex­
ample. The speaker system is equipped with:
– a 2­way bass reflex system
– a microphone input
– a line level input for audio devices
– an MP3 player with TWS function
– a Bluetooth receiver
– a 5­band equalizer
2 Overview
1 Slot for an SD memory card to replay MP3
files
2 Display of the MP3 player
3 USB port for a USB flash drive to replay
MP3 files
4 Control buttons for the MP3 player (see
chapter 4.4)
5 5­band equalizer for the mixed signal
6 Cooling fins for heat dissipation; must
never be covered!
7 Input jacks MIC IN (XLR and 6.3 mm, bal­
anced) for a microphone
8 Input jacks LINE IN (XLR, balanced and
RCA, unbalanced) for an audio device with
line level output (e. g. mixer, CD player)
4
0 dB
USB
–12
Hz 63 500 1k 3.2 k 12 k
9 Output LINE OUT (XLR and 6.3 mm, bal­
5
MP3
3
10
10 Volume control MP3 for the MP3 player
+12
0 10
MIC
0 dB
7
11
USB 11 Volume control MIC for the microphone
–12
MIC IN
Hz 63 500 1k 3.2 k 12 k
0 10
LINE
5
12
12 Volume control LINE for the input LINE IN
0 MP3 10
MASTER
8
LINE IN
10
13
13 Control MASTER for the total volume of
0 10
0 MIC 10
TREBLE
7
11
14
LINE OUT
MIC IN
14 Tone control TREBLE for the high frequen­
9
0 10
LINE
–12 +12
BASS
12
15
15 Tone control BASS for the low frequencies
0 10
8 –12 MASTER +12
LINE IN 16 Power LED ON
13
CLIP ON
17 16
17 Overload LED CLIP
0 10
TREBLE
18 POWER switch
14
LINE OUT
9
19 Power connector for connection to a mains
–12 +12
BASS
15
–12 +12
CLIP ON
17 16

3 Safety Notes

The product corresponds to all relevant direc­
18
tives of the EU and is therefore marked with
POWER
The product corresponds to the relevant UK
legislation and is therefore marked with UKCA.
19
WARNING The product uses dangerous
USE ONLY WITH A 250V FUSE
230 V~/50 Hz
18
POWER
CAUTION Never adjust the speaker sys­
19
USE ONLY WITH A 250V FUSE
230 V~/50 Hz
• The product is suitable for indoor use only.
Protect it against dripping water, splash
water and high air humidity. The admissible
ambient temperature range is 0 – 40 °C.
• Do not place any vessel filled with liquid on
the product, e. g. a drinking glass.
• The heat generated inside the speaker sys­
tem will be dissipated via the cooling fins (6).
Never cover the cooling fins. Never position
the speaker system directly against a wall,
always make sure the distance is sufficient.
• Immediately disconnect the product from the
mains socket,
1. if the product or the mains cable is visibly
2. if a defect might have occurred after the
3. if malfunctions occur.
In any case the product must be repaired by
skilled personnel.
• Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
• For cleaning only use a dry, soft cloth; never
use water or chemicals.
• No guarantee claims for the product and no
liability for any resulting personal damage or
material damage will be accepted if the prod­
uct is used for other purposes than originally
intended, if it is not correctly connected or
operated, or if it is not repaired in an expert
way. Likewise, no liability will be accepted for
any data loss caused by a defect or operating
anced) to route the mixed signal to an ad­
ditional active speaker system, for example
with Bluetooth receiver
input (7)
(8)
the speaker system
cies
socket (230 V/ 50 Hz)
mains voltage. Leave servicing
to skilled personnel. Risk of
electric shock!
tem to a very high volume.
Permanent high volumes
may damage your hearing!
damaged,
product was dropped or suffered a similar
accident,
errors and for any consequential damage of
this data loss.
If the product is to be put out of op­
eration definitively, dispose of the
product in accordance with local
regulations.
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL de­
clares that the radio equipment type WAVE­
12A / WAVE­15A complies with Directive
2014 / 53/ EU. The full text of the EU declaration
of conformity is available on the Internet:
www.monacor­international.com

4 Operation

4.1 Setting up the speaker system
Place the speaker system on a solid surface
and align it towards the audience. Place the
tweeter at ear level, if possible.
.
Alternatively, place the speaker system via
the stand sleeve on its lower side on a standard
speaker stand with a tube diameter of 35 mm
(e. g. from the PAST series).
As an installation aid for fixed installations,
two M8 threaded holes each are available on
the upper side and the lower side.
4.2 Remote control
The MP3 player is supplied with power by
means of a 3 V button cell. If the remote control
is delivered with the battery inserted, remove
the protective film (used to prevent the battery
from discharging) from the battery support.
The remote control will then be ready for op­
eration. When pressing a button, always point
the remote control at the IR sensor located
behind the protective grille of the bass speaker.
Make sure that there are no obstacles between
the sensor and the remote control.
Replacing the battery
1) Push the latch of the battery holder to the
right (arrow 1 in figure below) and remove
the holder (arrow 2).
1.
2) Remove the discharged battery and insert
the new battery (3 V button cell of type
CR 2025) with the positive pole facing up­
wards.
3) Push the holder back into the remote con­
trol.
Never put batteries in the household
waste. Always dispose of the batter­
ies in accordance with local regula­
tions.
4.3 Connection and operation
Before establishing or changing any connec­
tion, always switch off the speaker system and
the devices to be connected!
2.