Magellan Meridian Series User Manual page 83

The Magellan Secure Digital (SD) Memory Cards can be added to any of the
Meridian line of GPS receivers through the battery compartment. Magellan
offers the memory cards in 8, 16, 32 and 64 MB configurations. The addition of
the memory card to your Meridian will increase the amount of data that can be
uploaded to the Meridian from any of the Magellan MapSend CD-ROM
products.
To Add or Remove the memory card:
1. Turn the Meridian off.
2. Remove the battery door.
3. Remove both of the AA batteries.
4. To remove the card, push the card slightly towards the top of the
Meridian. You will feel a slight click which is the locking mechanism
disconnecting and then you will feel the memory card pushing
against your finger. Allow the memory card to slide back towards the
battery compartment. Now carefully continue to slide the memory
card out of the channel it's in and lift it out.
5. To install the card, hold it with two fingers with the label facing you.
Place the top of the memory card in the channel provided in the
battery compartment. Carefully push the memory card towards the
top of the Meridian receiver until you feel it lock into place. Do not
force the memory card. Forcing the memory card could cause
damage to the card and/or the Meridian receiver.
6. Reinstall the batteries into the battery compartment. Be sure to
observe the proper polarity.
7. Replace the battery compartment door.
8. Turn on the Meridian GPS receiver.
Magellan Meridian GPS Receiver
Appendix
73