Marking Your Position (Personalized) - Magellan 200 Reference Manual

Points of Interest

Marking Your Position (Personalized)

Normally, marking you position is simply a two button process, MARK and ENTER.
However, sometimes you will want to personalize the POI you are marking to make it
easier to identify later. You are able to change the icon, change the name, and create
a message. (You are also able to change the location coordinates as well as the
elevation. This changes the position that is being saved and is discussed in a
following section.)
1. Press MARK.
2. Use the Arrow joystick to highlight the field you want
to change.
3. Press ENTER.
4a. If the icon field was selected: Use the Arrow joystick
to select the icon desired and press ENTER. To aid in
your selection, the type of icon selected is displayed in
the information block at the top of the keypad.
4b. If the Name field was selected. Use the Arrow joystick
to select the character desired and press ENTER. If
you make a mistake, highlight Back and press ENTER.
To access the lower case characters, highlight Shift
and press ENTER. To clear everything and start over, highlight CLEAR and
press ENTER. When you are satisfied with the name, highlight OK and press
ENTER.
Note: User saved POI names can only be eight characters long (including
spaces).
4c. If the Message field was selected. Use the keypad displayed just as was
described in 4b to enter a message for this POI. Message fields can have up
to 30 characters, including spaces.
5. When the Icon, Name and Message fields are done, use the Arrow joystick to
highlight Save.
6. Press ENTER.
Mark
Icon Name
POI003
Location
34°06.560N
117°49.566W
Elevation
924
F
T
Message
CREATE MESSAGE?
Save
Cancel
Mark Screen with Name
field highlighted.
26