Starting The Preparation; Installing The Milk Pot On The Machine; Volume Of Milk; Volume Of Coffee - Krups EA819 ARABICA LATTE Manual

Starting the preparation

For a personalised cappuccino, the machine enables you to choose different volumes of milk and coffee, according to
your preferences.
- Press the recipe choice key

Installing the milk pot on the machine

Prior to first use, carefully clean the various elements.
The milk pot is composed of a plastic container (W), a lid (R) including a cassette (V) and a flexible tube (U) connecting
to the machine's drink outlet.
- Pour the milk in the pot (a minimum of 150 ml) (18).
- Put the lid on the pot by screwing it on (19).
- Lift the lock lever (20).
- Install the milk pot on the machine by connecting it to the steam outlet (21) then lower the lock lever (22).
- Insert the flexible tube in the cassette opening intended for this purpose (23) then place the other end under
the magnetic drink outlet (23).
- Check that the cappuccino/clean selection knob on the milk pot lid is properly set to the cappuccino position
(24).
Personalisation
Strength
- Choose the desired intensity by increasing or reducing the number of coffee beans
(25).

Volume of coffee

- Next, press the navigation key
reduce the volume using the keys

Volume of milk

- And finally, you may set the desired volume of milk
- Press the start/stop key
To stop the flow into your cup, press the start/stop key
You may also adjust the temperature of your coffee; to do so, press the settings and maintenance button
using the navigation key, position it on
BE CAREFUL, IF YOU INTERRUPT THE PREPARATION OF YOUR DRINK, STOPPAGE IS NOT
IMMEDIATE.
Rinse of the milk pot (approximately 30 seconds)
Each time a cappuccino recipe is prepared, the machine prompts you to perform a rinse of the milk pot via the appearance
of the pictogram (31). It is preferable to perform the rinse of your milk pot to guarantee the performance of your machine
and optimal hygiene. To perform this rinse, it is not necessary to empty the milk remaining in the milk pot.
- When the pictogram
- Turn the knob of the milk pot to the CLEAN position
- Ensure that the milk pot is properly connected to the machine and in locked position (lever lowered) (22).
- Press the START/STOP button
(17) until the pictogram is displayed.
to go to the setting of the final desired drink volume. You may increase and
(26).
(28).
and set the desired temperature level using the keys
is displayed, press the parameters button
(33), the rinse cycle starts.
using keys (27).
.
(31).
(32).
using the keys
then,
.
27