Page 1
Platinum 6000™ (Rev. 2) Quick Reference Guide For Photo Overlay and QRG Platinum 6000 ™ 5 min Mode 10 min 15 min mmHg kg/lbs mmHg mmHg A Cells B Cells For Rev. 1 keypad, see Part No. 27650011...
Page 2
Keypad Controls Power/Standby Lock/Unlock Mode: Select Immersion or Alternation Mode Immersion Therapy Alternation Therapy Autofirm: max inflate for transferring patient Microclimate Management: on by default; toggle to turn off Cycle Time: for Alternation Therapy only Alarm Silence: press to reset alarms Power Fail Warning Low Pressure Warning...
Page 3
Operating Instructions 1. Press and hold . Green LED indicates control unit is on; Amber LED indicates standby mode. 2. Surface should automatically enter Autofirm mode. If not, press to max inflate surface. 3. Transfer patient to surface. Setting Therapy Mode 1.
Page 4
Patient Specific Adjustments After setting Therapy Mode, customize the mattress for your patient by following three steps: Patient Height: Select and use until patient’s height is shown on display. Patient Weight: Select and use until patient’s kg/lbs weight is shown on display. Comfort Settings: Select to override auto pressure settings.
Page 5
Switching Units of Measurement The control unit’s default settings are standard units. Switch from Standard to Metric (or back): 1. Verify control unit is in standby or press for two seconds to place into standby. Amber LED will show. 2. Press and hold for five seconds.
Page 6
(amber LED). 3. If mattress is to be disconnected from control unit, place Transport Cap over hose connections. This card is not meant to replace product user manual. For complete manual, contact Sizewise. sizewise.com 800-814-9389 OPS-0047B-1118 27650013, Rev. 1.0...
Need help?
Do you have a question about the Platinum 6000 and is the answer not in the manual?
Questions and answers
Max number of layers of items is recommended between the patient and the mattress. IE brief, pad, sheet etc?