Lectronics DCHT Instruction Manual page 19

For body worn operation, this transmitter model has been tested and meets the FCC RF exposure
guidelines when used with the Lectrosonics accessories supplied or designated for this product. Use of
other accessories may not ensure compliance with FCC RF exposure guidelines. Contact Lectrosonics
if you have any questions or need more information about RF exposure using this product..
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment.
This device should be installed and operated so that its antenna(s) are not co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with ISED Canada radiation exposure limits as set forth for an uncontrolled
environment.
Cet appareil est conforme avec les normes d'Industrie Canada concernant les limites d'exposition aux
radiations pour un environnement incontrôlé.
This radio transmitter [IC: 8024A-DCHT, DCHT/E01] has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
Lectrosonics provides dipole "whip" antennas for use with the DCHT, DCHT/E01 transmitter.
The antennas are cut to the frequency range shown below and include a 50 Ohm SMA con-
nector.
Antenna Model
AMM19
AMM22
Rio Rancho, NM
Freq Range (MHz) Gain (dBi)
470.100 - 537.500
537.500 - 607.950
2.15
2.15
Digital Transmitter
19