HIKVISION DS-K1100 Series Connecting Manual page 2

DS-K1100 Series Card Readers Connect
Title: to DS-K1T105&DS-K1T200 Series
Access Control Terminal
Product: Access Control Device
3. Please check the rear panel of card reader and unscrew it, you could find DIP switch module;
The No. of DIP switch from left to right is 1~8:
Description of DIP Switch:
No.
1~4
5
6
7
8
RS485 Wiring
Step 1: DIP Switch
Please set the DIP switch firstly before connecting the external card reader, the binary value of the card
reader is 0100 0000, please set as the following picture;
Version:
Page:
Icon
Description
Address of RS485
Read card No. or file in card(Reserved)
Wiegand protocol or RS-485 protocol
Wiegand Protocol
(available when No. 6 is 1)
Matched Resistance(Reserved)
(available for RS-485 protocol)
v1.0 Date: 6/21/2017
2 of 4
Description
Represent 1 in binary mode
Represent 0 in binary mode
DIP Switch Status
1: 1
0: 0
1: read card No;
0: read file in card.
1: Wiegand protocol
0: RS-485 protocol.
1: Wiegand protocol of 26-bit;
0: Wiegand protocol of 34-bit.
1: Enable;
0: Disable.