WATERGUARD Solo User Manual

Home Maintenance....
The valve doesn't open or close.........................
If all controls are functioning as normal but the valve is failing to close, please see Routine
Maintenance below as the valve assembly may be blocked up.
How to manually bypass the valve to allow water flow.........................
WARNING The manual bypass must only be used in an emergency to restore the water
supply when the controller is damaged or there has been a long term loss of mains power.
Rotate the whole coil head as shown.
VALVE
NORMAL
NOTICE: THIS WILL DEACTIVATE WATER LEAK PREVENTION AND MAY
INVALIDATE YOUR BUILDINGS INSURANCE.
General Maintenance....
Automatic Testing – The valve driver is programmed to automatically close and open the valve
every 24 hours. This tests both the valve assembly and controls.
Routine Maintenance – This system requires minimal maintenance and will only require the
following:
•
In hard water areas it is recommended that the valve assembly is dismantled and cleaned
with limescale remover every 12 months as build up can cause the unit to fail.
• After continued power loss the valve driver back up battery may need replacing. It is
recommended that a suitably qualified engineer changes the battery (3V lithium, size code
CR123A) after firstly turning off mains power to the unit.
Contact Us....
If you require any further assistance operating the Waterguard Solo or if the Solo is not functioning
correctly, please call our friendly customer service team on 01226 244200.
Waterguard Services Limited. Registered address: 22 Oakwell Business Centre, Oakwell View, Barnsley, South
Yorkshire, S71 1HX. Tel: 01226 244200. Email: enquiries@waterguard.co.uk.
Water Leak Detection Equipment
Waterguard Solo
User Guide V19
VALVE ON
BYPASS
To familiarise yourself with your installed Waterguard System please read this user guide in full. If you
have any further questions, please contact the office.
© 2019 Waterguard Services Limited, All Rights Reserved