Download Print this page

WATERGUARD SOLO User Manual

Hide thumbs Also See for SOLO:

INFORMATION

To familiarise yourself with your installed Waterguard System please read this user guide in full. If

you have any further questions, please contact the office on 01226 244200.

This system protects properties by monitoring water usage from the incoming water mains using

a flow sensor that allows continuous water flow for a limited time before the controller suspects a

leak and automatically shuts off the water with a solenoid valve.

The Waterguard Solo has one level of guard (maximum time of continuous flow) which is usually

set by the installer, landlord or concierge with the controls often located in riser cupboards or

basements.

Dedicated technical helpline: 01226 397987

Waterguard Solo User Guide

Table of Contents

Do you have a question about the SOLO and is the answer not in the manual?

Page 1 The Waterguard Solo has one level of guard (maximum time of continuous flow) which is usually set by the installer, landlord or concierge with the controls often located in riser cupboards or basements.
Page 2 Press and hold the Solo button for approximately 25 seconds, the Solo is now in set up mode. Ensure you do not release the button after the initial 25 seconds and the Solo will flash as below in 5 second intervals.
Page 3 Solo once power is restored. Check the LED on the Solo switches on and is a solid red light when mains power is applied. Run the water in the property (the Solo will perform 2 brief flashes every 2 seconds indicating that water is flowing).