WATERGUARD Puddle User Manual

Water leak detection equipment

Water Leak Detection Equipment

Waterguard Commercial Puddle Sensor – Alarm Only

User Guide V19

System Profile....

The Waterguard Puddle is the latest development in multi zone water leak detection technology. Its

language free control unit which has 5 water leak detection channels, requires no setup or

maintenance making it the easiest system on the market to install and operate.

Your system will be monitoring up to 5 water leak detection channels using various water sensing

devices dependent on application. These include, water sensing cable or tape, water sensing feet

and/or float switches.

Details of each device should be recorded and supplied to you by the system installer. However,

please do not hesitate to contact the office for any information we may hold.

Please see reverse for operating instructions.

Table of Contents

Need help?

Do you have a question about the Puddle and is the answer not in the manual?

Page 1 User Guide V19 System Profile…. The Waterguard Puddle is the latest development in multi zone water leak detection technology. Its language free control unit which has 5 water leak detection channels, requires no setup or maintenance making it the easiest system on the market to install and operate.
Page 2 Test Mode…. To test the operation of the Puddle, rapidly press the button 5 times. This will simulate an alarm on all channels in use. Example, a Puddle which is using 2 of the channels will flash red and beep once then flash red and beep twice to indicate that channels one and two are installed and operating correctly.