1. Manuals
  2. Brands
  3. WATERGUARD Manuals
  4. Security Sensors
  5. PUDDLE
  6. Installation manual

WATERGUARD PUDDLE Installation Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

IMPORTANT!
PLEASE READ THIS GUIDE CAREFULLY AND IN FULL BEFORE INSTALLING.
TAPE BECOME CONTAMINATED.
COMPONENTS.
IMPORTANT: INSTALLATION MUST BE CARRIED OUT ONLY BY
THOSE COMPETENT IN ELECTRICAL INSTALLATION. ANY
DAMAGES INCURRED DUE TO IMPROPER INSTALLATION ARE NOT
COVERED UNDER WARRANTY.
INFORMATION
The Waterguard Puddle is available in two different versions. Alarm only, which includes only the Puddle controller and
up to 5 lengths of water sensing tape/cable and/or foot probes. And automatic shut off versions, this includes
everything as the alarm only but also includes a valve driver and up to 3 isolation valves. Please check your version
before following wiring instructions.
INSTALLER INFORMATION
WHAT YOU WIIL NEED
ITEMS:
•
2 Core Flex - PVC 2 Core Flat Flexible Cable
(2192Y) min 0.75mm2 if connecting to BMS or
SMS service.
•
1/2 x single pattress box
Dedicated technical helpline: 01226 397987
STORAGE:
KEEP IN A DRY PLACE PRIOR TO INSTALLATION TO AVOID POSSIBLE DAMAGE TO INTERNAL
KEEP CLEAN:
DO NOT LET WATER SENSING
TOOLS:
•
Flat-head screwdriver.
•
Drill or hole punch for electrical/conduit
entries.
•
Phillips screwdriver.
*No fittings are supplied for the installation of
.
plumbing components
© 2024 Waterguard Services Limited, All Rights Reserved
Waterguard Puddle Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PUDDLE and is the answer not in the manual?

Questions and answers

Related Manuals for WATERGUARD PUDDLE

Summary of Contents for WATERGUARD PUDDLE

  • Page 1 COVERED UNDER WARRANTY. INFORMATION The Waterguard Puddle is available in two different versions. Alarm only, which includes only the Puddle controller and up to 5 lengths of water sensing tape/cable and/or foot probes. And automatic shut off versions, this includes everything as the alarm only but also includes a valve driver and up to 3 isolation valves.

  • Page 2: System Information

    1/4" hold-down clips and adhesive Flat ribbon type clips, self-adhesive clips Connection Purpose built leader cable (connection between Puddle controls and water sensing device) Installation The location of water sensing cable is critical to the effective operation of this system. Great care should be taken to locate away from areas likely to suffer from normal dampness and condensation, as this may trigger false alarms.

  • Page 3: Fitting The Controls

    WIRING – ALARM ONLY 1. Wire each water sensing device to each of the numbered channels on the Puddle controller. Leader cable (connecting cable between the controls and sensing tape/cable) lengths are specified upon quotation and made to measure.
  • Page 4 Ensure to record the water sensing device and its location using the location log opposite. Connect ALARM OUT terminal on the Puddle controller to PIR terminal on the Valve Driver using 2 core flex, + to + and – to SW.

  • Page 5: Technical Support

    All information provided, including installation is held to be reliable. Clients should however independently evaluate the suitability of each system to their individual application. Due to continual development specifications are subject to regular change without notice.

  • Page 6: Site Information

    If for any reason the installed system fails on any of the points below, please call our technical line in the first instance on 01226 397987. Use in conjunction with the supplied Puddle installation instructions. This certificate forms proof of commissioning and testing, the below commissioning information is correct as of the date of commissioning and may have been changed.

Table of Contents