Table of Contents
Advertisement
Available languages
Available languages
Make sure the extension cord is in good condition before using. Always use the proper
USE OF EXTENSION CORDS
size extension cords with the tool – that is, proper wire size for various lengths of cord and
heavy enough to carry the current the tool will draw. Use of an undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. For proper size cords see
chart below.
120V
Volts
240V
More
Ampere Rating
Than
0
6
10
12
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
MOTOR
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC or
DC power. This information is printed on the nameplate. Lower voltage will cause loss of
power and can result in over-heating. All Black & Decker tools are factory-tested; if this
tool does not operate, check the power supply.
FUNCTIONAL DESCRIPTION
1. Two speed switch
2. Hang hole
3. Air vents
4. Hot air nozzle
5. Temperature adjustment knob
Tool Operation
The position of the switch controls both the fan speed and the heat output of the gun.
SWITCH - FIGURE B
There is considerable overlap in the temperature ranges with the use of the temperature
adjustment knob.
• To turn the tool on in low air speed, low heat, slide the switch (1)
to the position marked "I".
• To turn the tool on in high air speed, high heat , slide the switch
(1) to the position marked "II".
• To turn the tool off, slide the switch (1) to the position marked "0".
All manuals and user guides at all-guides.com
Minimum Gauge for Cord Sets
0-25
26-50
Total Length of Cord in Feet
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
American Wire Gage
Than
-
6
18
-
10
18
-
12
16
-
16
14
51-100
101-150
101-200
201-300
16
16
14
16
14
12
16
14
12
12
Not Recommended
A
4
6
3
5
1
2
B
1
Advertisement
Table of Contents
