Lincoln Electric POWERTEC i380C ADVANCED Operator's Manual page 20

The limits can be set for:

Welding Current

Wire Feed Speed

Welding Voltage

Wave Controls
To set the range:

Enter to the Settings and Configuration Menu.

Use The Right Knob [36] to highlight the "Limits"
icon.
Figure 34.

Press the Right Knob [36] to confirm. List with
available job will be displayed on the screen.
Figure 35.

Use the Right Knob [36] to highlight the job.

Press the Right Knob [36] to confirm selection.
Figure 36.

Use the Right Knob [36] to choose the parameter
which will be changed.

Press the Right Knob [36] to confirm.

Use the Right Knob [36] to change the value. Press
the Right Knob [36] to confirm.

Figure 37. shows the effect of changing the values of
parameters.
English

Press the Button [37] to exit with changes.
Display Configuration
Two Display Configuration are available:
Table 9. Display Configuration
Standard view
Advanced view
To set the Display Configuration:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Display
Configuration icon.

Press the Right Knob [36]. The Display Configuration
Menu is shown on the display.

Use the Right Knob [36] to choose the display
configuration.
18
Figure 37.
Figure 38.
Figure 39.
English