Connecting The Boom Lights (Optional Accessory) - Nice WIDE S Instructions And Warnings For Installation And Use

9.4 CONNECTING THE BOOM LIGHTS (OPTIONAL
ACCESSORY)
To perform the installation:
1. put the boom in the vertical position
2. loosen the 4 screws that fasten the boom cover (A)
53
3. remove the boom temporarily
4.
insert the cable grommet through the specially configured
hole (B)
54
B
5. feed the lights cable (C) through the rubber impact protector
and, if necessary, use a fish tape to facilitate the operation
55
C
C
6.
7.
a
A
56
8.
m
57
Fuse F8A
if necessary, shorten the lights cable by cutting it only in one
of the points indicated by an appropriate mark. After cutting
the cable, the cap of the cut end must be shifted to close
the new end
insert the wiring cable first through the hole on the boom
support then through the hole in the cubicle
leave a bit of cable inside the boom support, so that
the boom can be rotated without causing any ten-
sion along the cable.
connect the lights cable to terminals 3-4 on the control unit
The output has poles: if the lights fail to switch on
according to the settings, the cables connected to
the terminal must be inverted.
Fuse F1A
24V
24V
10
9
8
7
6
-
5
4
3
+
ENGLISH – 31