Further Details (Accessories); Connecting An Sm-Type Radio Receiver; Connecting And Installing The Back-Up Battery - Nice WIDE S Instructions And Warnings For Installation And Use

TERMINAL LEDS ON THE CONTROL UNIT
Status
OP LED
OFF
On
CL LED
OFF
On
FCA LED
OFF
On
FCC LED
OFF
On
FURTHER INFORMATION
9
(Accessories)
10

FURTHER DETAILS (Accessories)

9.1 CONNECTING AN SM-TYPE RADIO RECEIVER

The control unit has a slot for mounting radio receivers with SM
connector (optional accessories) belonging to the SMXI, OXI, etc.
families, which can be used to remotely control the control unit
through transmitters that intervene on the unit's inputs.
f
Before installing a receiver, disconnect the power
supply to the control unit.
To install a receiver ("Figure 47"):
1. insert the receiver (A) in the appropriate slot (B) on the con-
trol unit's electronic board.
47
A
B
The association between the radio receiver output and the control
performed by the motor is shown in "Table 12":
l
For further information, consult the specific manual
of the receiver.
Meaning
Everything normal
Intervention of Open input
Everything normal
Intervention of Close input
Intervention of the limit switch
No intervention of the limit switch
Intervention of the limit switch
No intervention of the limit switch
Possible solution
Open input not active.
It is normal if one of the devices connected to the Open input is
active.
Open input not active.
It is normal if one of the devices connected to the Close input is
active.
The boom is in the opening position.
The boom is in a position other than the opening position.
The boom is in the closing position.
The boom is in a position other than the closing position.
SMXI / SMXIS OR OXI / OXIFM / OXIT / OXITFM IN MODE 1 OR
MODE 2
Receiver output
Output No. 1
Output No. 2
Output No. 3
Output No. 4
Output No. 5
Output No. 6
Output No. 7
9.2 CONNECTING AND INSTALLING THE BACK-
UP BATTERY
f
The electrical connection of the battery to the con-
trol unit must be made only after completing all the
installation and programming stages, as the battery
is an emergency power supply.
f
Before installing a back-up battery, disconnect the
power supply to the control unit.
To install and connect the battery:
1.
unhook the control unit box from its position
2. open the box
3.
access the battery compartment by releasing the catch (A)
and lifting the part (B)
48
Command
"Step-by-Step"
"Stop"
"Open"
"Close"
Courtesy light
Radio channel 1
Radio channel 2
B
A
Table 12
ENGLISH – 29