TP-Link EAP115 Quick Installation Manual page 4

English
The EAP can only be powered by a PSE device, such as a PoE
switch. A DHCP server (typically a router) is required to assign
IP addresses to the EAPs and clients in your local network.
The management host can be in the same or different network
segment with the EAPs.
Pre-Installation Checklist
Before installation, be sure that you have the following items:
• A pre-installed wall junction box
• An RJ45 plug
• A triangular screwdriver (Only for EAP115-Wall)
• A Phillips screwdriver
• A PoE switch
Installation Steps
The EAP can be mounted into either an 86mm wall junction box
or a standard EU wall junction box. The junction box should be
pre-installed with a running-in-wall Ethernet cable connected to
a PoE switch.
86mm wall Standard US wall
Standard EU wall
junction box junction box
junction box
(Only for EAP225-Wall)
2