HELIX P TWO Manual page 21

Examples for speaker configurations
2-channel fullrange application
Component system
Left Right
2-channel subwoofer application in combination with HELIX P SIX DSP MK2 incl. HEC module
P SIX DSP MK2
Outputs
The connection of the
two amplifiers is made by
a digital audio cable.
Optical Out
Remote Out
Note: The values listed here are empirical values that have been approved as useful in practice. Depending on the size of the loudspeaker
we recommend the following highpass filter settings: ca. 50 Hz for 6.5"/16.5 cm LS; ca. 70 Hz for 5.25"/13 cm LS; ca. 100 Hz for 4"/10 cm LS
Highpass filter
HPF
VC 1
50 - 100 Hz
Subwoofer with dual voice coil
Inputs
Optical Input
REM
The crossover frequency for the high- and lowpass will be adjusted in the
P SIX DSP MK2 by using the DSP PC-Tool Software. To deactivate the filters
of the P TWO set the X-Over switch to "FULL" and the SPDIF Direct In switch
to "ON".
2-channel subwoofer application
Subwoofer with dual voice coil
Bandpass
VC 2
Highpass filter
VC = Voice coil ca. 15 Hz
P TWO
VC 1 VC 2
VC = Voice coil
BPF
Lowpass filter
ca. 80 Hz
Switches
SPDIF Direct
In: ON
X-Over:
FULL
21