Intended Use; Scope Of Delivery - Kathrein Euroline Series Manual

Offset Parabolic Antennas
Features
■
Aluminium reflector, powder-coated
■
Back of galvanised sheet steel
■
LNB carrier arm of aluminium
■
Galvanised steel mast clamps and threaded clamps
(completely pre-mounted)
■
Nuts and bolts in stainless steel
■
Colours: KEA 650/750/850/1000 – graphite (similar to
RAL 7012), red brown (similar to RAL 8012), white (similar to
RAL 9002)
■
Items supplied: reflector with pre-mounted mast and feed
system support
■
Only possible for KEA 750/850/1000: For mounting two LNBs
on the boom (multi-feed reception) to receive the signals of
satellites up to 6° apart (e.g. ASTRA/EUTELSAT HOTBIRD).
The KEZ 02 multi-feed bracket (order no. 20010056) is addi-
tionally required, see Accessories (Optional, Not Included)).

Intended Use

The parabolic antennas are intended solely for the reception of satellite signals and for use only as domestic antennas. DIN EN
60728-11 specifies that a domestic antenna should have no more than 6 m free mast length and a fixed-end moment up to 1650 Nm.
The parabolic antennas are designed for use with a feed system (LNB) for reception of the signals from one satellite position, or two
feed systems for multi-feed applications for reception of the signals from two satellite positions with up to 6° satellite spacing (in case
of KEA 750/850/1000, with KEZ 02).
● It is unsuitable for mounting on structures that are liable to vibration.
● Make sure to comply with the values for the maximum wind load listed in the Technical Data. If this load is exceeded, parts could
break away!
● The feed systems and instructions for their installation are not included in the scope of supply of the parabolic antenna.
● Do not use the parabolic antenna for purposes other than those listed in this manual! In particular, never
– modify any of its components or
– fit any components other than those expressly intended by the manufacturer for use with the antenna.
Non-compliance may lead to the antenna no longer being sufficiently stable and safe!
● The laws and standards currently valid for the installation and operation of the antenna are binding and are to be observed and
applied without fail!
Any use other than that specified or failure to observe these application notes will invalidate the warranty or guarantee.
Tip
Keep these instructions for further reference and pass them on to the next owner of the antenna..

Scope of Delivery

Scope of delivery KEA 650/750:
● pre-mounted support arm
● reflector
● 4 x M6 x 35 Inox screws
● 4 x M6 Inox self-locking nuts
● Instructions for Use
Scope of delivery KEA 850/1000:
● pre-mounted support arm
● reflector
● 6 x M6 x 35 Inox screws
● 6 x M6 Inox self-locking nuts
● instructions for use
KEA 650
KEA 750
KEA 850
KEA 1000
1 / 10