Download Print this page
Pepperl+Fuchs ecom Ex-Handy 10 Quick Start Manual
Pepperl+Fuchs ecom Ex-Handy 10 Quick Start Manual

Pepperl+Fuchs ecom Ex-Handy 10 Quick Start Manual

Hide thumbs Also See for ecom Ex-Handy 10:

Advertisement

Quick Links

Battery
The battery of the feature phone is not fully charged.
It is recommended to charge the phone for five hours before
using it for the first time. The full capacity of the battery is
reached after 3-4 complete charge/discharge cycles.
Warranty
The warranty of this product follows the General Conditions
of Delivery and Payment of Pepperl+Fuchs GmbH, which are
available at www.pepperl-fuchs.com, or alternatively they can
be requested directly from the manufacturer.
Support
E-Mail: support@ecom-ex.com
Note:
Please also observe the safety requirements in the specific
safety instructions and the information in the full user guide
for your device. The documents can be downloaded from the
relevant product page at www.ecom-ex.com
Copyright
2018 ecom instruments GmbH.
©
The contents of this document, either in part or in their entirety, may not be reproduced, forwarded, distributed
or saved in any way without ecom instruments GmbH prior written consent.
The contents of this document are presented as they currently exist. ecom instruments GmbH does not provide
any express or tacit guarantee for the correctness or completeness of the contents of this document, including,
but not restricted to, the tacit guarantee of market suitability or fitness for a specific purpose unless applicable
laws or court decisions make liability mandatory. ecom instruments GmbH reserves the right to make changes
to this document or to withdraw it any time without prior notice.
DOCT-6426 | 01/2019
WEEE-Reg.-Nr. DE 934 99306
Subject to change without notice.
ecom instruments GmbH | Industriestraße 2 | 97959 Assamstadt | Germany
Phone +49 62 94 42 24 0 | Fax +49 62 94 42 24 100
sales@ecom-ex.com | www.ecom-ex.com
Intrinsically safe feature phone Ex-Handy 10
QUICK START GUIDE
THE NEXT GENERATION FEATURE PHONE FOR IIOT

Advertisement

loading

Summary of Contents for Pepperl+Fuchs ecom Ex-Handy 10

  • Page 1 Warranty The warranty of this product follows the General Conditions of Delivery and Payment of Pepperl+Fuchs GmbH, which are available at www.pepperl-fuchs.com, or alternatively they can be requested directly from the manufacturer.
  • Page 2 How to insert the nano-SIM card Receiver Step 1 Proximity/Light sensor To insert the nano-SIM card unscrew the two cover screws in Alarm key a counter clockwise direction and remove the SIM card cover. Power key Please use the screwdriver Torx Touchdisplay T8 provided with the device.