Getting Started - NAD CI 8-120 DSP Owner's Manual

GETTING STARTED

WHAT'S IN THE BOX
Packed with your CI 8-120 you will find
•
Two detachable mains power cord
• 4 pieces of 4-position terminal block (for SPEAKERS)
•
1 piece of 2-position terminal block (for 12V TRIGGER )
• 4 pieces of feet with mounting screws
•
Quick Setup Guide
QUICK START
Refer to the supplied CI 8-120 Quick Setup Guide for basic instructions in
setting up your new NAD CI 8-120. The following important notes must
also be observed when setting up your CI 8-120.
IMPORTANT SETUP NOTES
• Before setting up or making connections, ensure that the CI 8-120 and
other devices to be connected to CI 8-120 are unplugged or powered
down.
•
Connect external speaker cables to supplied SPEAKERS terminal block
ensuring that the connections match CI 8-120's rear panel SPEAKERS
terminal markings.
•
Bare wire or loose strands from the speaker cables must not touch the
rear panel or other speaker terminals.
•
After installing the external speaker cables to the supplied SPEAKER
terminal blocks, plug in the wired up SPEAKER terminal blocks to
corresponding SPEAKERS (1- 8) rear panel terminals of CI 8-120.
•
Connect corresponding end of the AC power cord to CI 8-120's AC
mains input and the AC power cord's plug connected to mains power
outlet.
• Press front panel POWER button to switch ON CI 8-120 from standby
mode. Line input channels with active input signal will have their
corresponding front panel LED indicators illuminated blue.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your CI 8-120 arrived.
Should you move or otherwise need to transport your CI 8-120, this is by
far the safest container to do so. We've seen too many otherwise perfect
components damaged in transit for lack of a proper shipping carton, so
please: Save that box
4