Operation - EuroLite FL-100 User Manual

INSTALLATION
Inserting/Replacing the batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment.
Caution!
Danger of explosion when batteries are replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
Mounting
When standing the device on a plane surface, please extract the 3 legs.
If the device is used as torch, please extract the 3 legs and insert them in the fixation holes of the shaft.
Hanging installation:
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
Before rigging make sure that the installation area can hold a minimum point load of 5 times the device's
weight.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Operation via power unit
Caution: Before connecting the power unit, the batteries must be removed.
Connect the connection cable of the power-unit (6 V DC, 700 mA) with the DC IN-socket. Plug the power unit
into your outlet.

OPERATION

Before starting operation make sure that the silk cannot be drawn into the intake of the ventilation fan. With
the POWER-switch, you can switch the device on and off.
8