Download Print this page

Black & Decker 618898-00 Instruction Manual

Black & decker laser level instruction manual.
Hide thumbs
   

Advertisement

INSTRUCTION MANUAL
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
IF YOU SHOULD HAVE A QUESTION OR EXPERIENCE A
PROBLEM WITH YOUR BLACK & DECKER PRODUCT,
CALL 1-800-544-6986
BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No., TYPE No., A N D
D ATE CODE (e.g. 20000130M). IN MOST CASES, A BLACK & DECKER R E P R E S E N TATIVE CAN RESOLV E
YOUR PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A C A L L .
YOUR FEEDBACK IS VITA L TO BLACK & DECKER.
S AVE THIS MANUAL FOR FUTURE REFERENCE.
VEA EL ESPAÑOL EN LA CONTRAPORTADA.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y P Ó L I Z A DE GARANTÍA.
ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE USAR EL P R O D U C TO.
Cat N o BDL200S Form # 618898-00 (MAY- 0 4 - R E V.1) Copyright © 2004 Black & D ecker Printed in China
WARNING: Read and understand all instructions. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious personal injury.
S AVE THESE INSTRUCTIONS

Safety Instructions

DANGER: Laser Radiation, avoid direct eye exposure, serious eye injury can re s u l t .
• Do not use optical tools such as a telescope or transit to view the laser
beam.
• Position the laser so unintentional eye contact will be avoided.
• Do not operate the laser around children or allow children to operate the
l a s e r.
• Do not disassemble. Modifying the product in any way can increase the risk
of laser radiation.
W A R N I N G : Use of controls or adjustments or performance of procedures other than those
specified in this manual may result in hazardous laser radiation exposure.
• Do not operate in explosive atmospheres, such as in the presence of flammable liquids,
gases, or dust.
• Use only with the specifically designated batteries. Use of any other batteries may create a
risk of fire.
• Store idle product out of reach of children and other untrained persons. Lasers are
dangerous in the hands of untrained users.
• Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one laser, may create a risk of injury when used on
another laser.
• Repairs and servicing MUST be performed by a qualified repair facility. Repairs performed
by unqualified personnel could result in serious injury.
• Do not remove or deface warning labels. Removing labels increases the risk of exposure to
r a d i a t i o n .
• For indoor use only.
• This product is intended for use in a temperature range of 41°F(5°C) - 104°F(40°C).
C A U T I O N : Use caution when drilling, nailing or cutting into walls, floors and ceilings which
may contain electrical wiring or pipes. Always turn off the power when working near
electrical wires.
C A U T I O N : Use of controls or adjustments or performance of procedures other than those
specified in this manual may result in hazardous laser radiation exposure.
First Aid Measures for Bubble Vial Content
In case of skin contact, flush with soap and water. In case of eye contact, flush with flowing water.
If swallowed, get medical help.
Material Safety Data Sheet (MSDS) available from 1-800-544-6986.
For your convenience and safety, the following labels are on your laser.
Se protéger contre toute exposition – Des radiations laser sont émises par cette ouverture.
Evite la exposición a la radiación láser emitida por esta apertura.
The label on your tool may include the following symbols.
V ..........................volts
nm ........................wavelength in nanometers IIIa........................Class IIIa Laser
Installing the Battery
Ensure laser on/off switch is in the full off position. Remove the battery compartment cover
(D) by lifting either end as shown in Figure 1. Insert a fresh 9 volt battery making sure to
match (+) and (-) terminals correctly. Replace the battery compartment cover.
Catalog No. BDL200S
mW......................milliwatts
A
B
C
E
H
1
3
WARNING: Batteries can explode, or leak, and can cause injury or fire.
To reduce this risk:
• Carefully follow all instructions and warnings on the battery label and
package.
• Always insert battery correctly with regard to polarity (+ and -), marked on
the battery and the equipment.
• Do not short battery terminals.
• Do not charge battery.
• Remove dead battery immediately and dispose of per local codes.
• Do not dispose of battery in fire.
• Keep batteries out of reach of children.
• Remove battery if the device will not be used for several months.
S AVE THESE INSTRUCTIONS

Operating Instructions

Expanding Wall Plug
The expanding wall plug (A) is suitable for use in most wall construction except drywall. F o r
drywall, use the drywall pin (B) described below.
Insert expanding legs of the wall plug in a predrilled hole in wall (4mm to 8mm diameter
holes). The legs must be fully closed prior to inserting in hole. Make sure the stationary ring
(b l a c k) is seated firmly against the wall surface and while gripping the stationary ring
s e c u r e l y, turn rotating ring (o r a n g e) clockwise (per arrow shown on ring) to tighten plug to
wall. To remove from wall, grip stationary ring securely and turn rotating ring in opposite
direction to loosen.
C A U T I O N : Always be sure the expanding wall plug is in a safe position when not in use.
D rywall Pin
C A U T I O N : Pin is sharp and should be handled with care. N O T E : The drywall pin(B) can
only be used for drywall, NOT other surfaces including plaster. To press pin into drywall, first
expose pin by rotating pin base from opposite side. While maintaining pressure on pin base,
insert pin straight and seat firmly against drywall surface as shown in Figure 2. The drywall pin
should always be pushed in by hand and never driven by a hammer. To remove drywall pin
from the wall, pull out straight.
CAUTION: Always be sure drywall pin is closed when not in use.
Avoid exposure-Laser radiation
emitted from this aperture.
Se protéger contre toute
exposition – Des radiations
laser sont émises par cette
ouverture
Evite la exposición a la
radiación láser emitida por
esta apertura.
F E AT U R E S
A.) Expanding Wall Plug
B.) Drywall Pin
C.) Laser On/Off Button
D.) Battery Compart m e n t
C o v e r
E . ) Magnetic Mount
F.) Horizontal Bubble Vi a l
D
G.) Ve rtical Bubble Vi a l
H.) Level Indicators
I.) Laser Line
F
G
I
2

Advertisement

   Summary of Contents for Black & Decker 618898-00

  • Page 1: Safety Instructions

    ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE USAR EL P R O D U C TO. Cat N o BDL200S Form # 618898-00 (MAY- 0 4 - R E V.1) Copyright © 2004 Black & D ecker Printed in China WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.

  • Page 2

    • Make sure laser is as square as possible to flat surface to ensure proper line projection. S t o r a g e Always store the laser level indoors and in its protective case. M a i n t e n a n c e Use only mild soap and damp cloth to clean the tool.

  • Page 3: Instrucciones De Seguridad

    El láser puede ser utilizado en diversas direcciones. La Figura 3 ilustra la aplicación típica del ‘Laser Level’ (nivel láser) cuando es montado en la pared. NIVELACIÓN: 1.) Montaje en la pared con el perno de anclaje expandible o la clavija para tablero de yeso: Asegúrese siempre de que el perno de anclaje expandible o la clavija...

  • Page 4

    Para reparación y servicio de sus herramientas eléctricas, favor de dirigirse al Centro de Servicio más cercano: CULIACAN, SIN MONTERREY, N.L. Av. Francisco I. Madero Av. Nicolás Bravo #1063 Sur No.831 (667) 7 12 42 11 (81) 8375 2313 Col. Industrial Bravo Col.

This manual also for:

Bdl200s

Comments to this Manuals

Symbols: 0
Latest comments: