Table of Contents
Advertisement
34
RECORDING
EN
Fade/Wipe Effects
These effects let you make pro-style scene
transitions. Use them to spice up the transition
from one scene to the next. You can also vary
transitions from scene to scene.
IMPORTANT:
Some Fade/Wipe Effects cannot be used with
certain modes of Programme AE with special
effects (
pg. 36). If an unusable Fade/Wipe
Effect is selected, its indicator blinks or goes
out.
START/STOP Button
MODE Dial
MENU Wheel
To Deactivate The Selected Effect . . .
.... select "OFF" in step 4.
NOTES:
You can extend the length of a Fade or Wipe
by pressing and holding START/STOP.
If the power is turned off after a scene is
finished recording, the stored point is erased,
disabling the Picture Wipe/Dissolve combina-
tion. When this happens, the Picture Wipe/
Dissolve indicator blinks. Also note that
power shuts off automatically if 5 minutes
elapse in the Record-Standby mode.
Picture Wipe/Dissolve cannot be used when
the MODE Dial is set to "
All Fade/Wipe Effects cannot be used when
the MODE Dial is set to "
The sound at the end of the last recorded
scene is not stored.
VMD22 EN(34/65)
Advanced Features For Video And D.S.C. (cont.)
FADE/WIPE SELECTION (
,
Fade or Wipe works when video recording is started or
when you stop recording.
1
Set the POWER Switch to "
down the Lock Button located on the switch and the
MODE Dial to "VIDEO" or "
Operation Switch to "
fully or open the LCD monitor fully.
2
Press the MENU wheel. The Menu Screen appears.
3
Rotate the MENU wheel to select "
4
Rotate the MENU wheel to select the desired
POWER Switch
function, then press it. Selection is complete.
•The FADER/WIPE Menu disappears and the effect is
Lock Button
5
Press START/STOP to activate the Fade-in/out or
Wipe-in/out.
Operation Switch
PICTURE WIPE OR DISSOLVE SELECTION
(
,
The Picture Wipe or Dissolve works when video recording
is started.
1
Follow steps 1 through 4 above.
2
Engage the Record-Standby mode.
If you select Picture Wipe/Dissolve during
recording . . .
.... press START/STOP when one scene is finished.
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
.... press START/STOP to start recording and press it
If you select Picture Wipe/Dissolve during Record-
Standby mode after performing a Picture Wipe/
Dissolve . . .
".
.... the point at which the scene ended is already
".
3
If you start recording a new scene within 5 minutes of
the end of the previous recording (without having
turned the camcorder's power off), the previous scene
wipes out, revealing the new scene.
34
,
,
,
and
". Pull out the viewfinder
reserved. The indicator representing the selected
effect appears.
,
,
,
,
The point at which the scene ended is stored in
memory.
again when one scene is finished. The point at
which the scene ended is stored in memory.
stored in memory.
29/08/00, 15:12
,
,
,
,
)
" while pressing
", then set the
", then press it.
and
)
Advertisement
Table of Contents
