THOMSON VMD 22 User Manual page 25

24
RECORDING
EN
POWER Switch
SNAPSHOT Button
MENU Wheel
Video image
Still image
VMD22 EN(02/33)
Advanced Features For Video And D.S.C. (cont.)
Dual Shooting
Lets you record images on a tape and store still images in a
FOCUS Button (3)
MultiMediaCard simultaneously. In other words, it is
possible to store still images in the MultiMediaCard
without interrupting image recording on the tape.
1
2
Lock Button
Operation Switch
3
MODE Dial
NOTES:
If SNAPSHOT is pressed in the Record-Standby mode,
only a still image is stored in the MultiMediaCard. Video
recording does not take place.
If SNAPSHOT is pressed when "DIS" is set to "ON"
(
The Stabiliser is less effective in the DUAL mode than in
other modes.
The flash is disabled during video recording.
Released position Still images are stored in the MultiMediaCard in VGA
mode file size (
When the MODE Dial is set to "DUAL", all Fade/Wipe
Effects and some Programme AE with special effects
cannot be used (
Half-pressed
position
Fully-pressed
position
24
Set the POWER Switch to "
down the Lock Button located on the switch and the
MODE Dial to " " . Pull out the viewfinder fully
or open the LCD monitor fully.
While recording to a tape, press SNAPSHOT halfway.
A still image is displayed in the lower right corner of
the screen where the video image being recorded is
displayed.
•At this moment, if you release SNAPSHOT,
snapshot recording will be cancelled.
Press SNAPSHOT fully. The displayed still image is
stored in the MultiMediaCard.
pg. 28), the Stabiliser will be disabled.
pg. 15).
pg. 34 – 36).
29/08/00, 14:41
" while pressing