THOMSON VMD 22 User Manual page 8

1
2
BATT. RELEASE
Switch
ATTENTION:
Before detaching the power source,
make sure that the camcorder's power
is turned off. Failure to do so can result
in a camcorder malfunction.
To AC outlet
AC Power
Adapter/
Charger
To DC OUT
terminal
To battery
pack mount
VMD22 EN(02/33)
USING THE BATTERY PACK
1
Insert the terminal end
battery pack mount, then firmly push the end
the battery pack in the direction of the arrow until it
locks into place as shown in the illustration.
•If the battery pack is attached in the wrong position,
To Detach The Battery Pack . . .
.... while sliding down BATT. RELEASE, detach it.
Approximate recording time
Battery pack
CCA 681
NOTES:
Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
USING AC POWER
Power cord
Use the AC Power Adapter/Charger (connect as shown in
the illustration).
NOTES:
The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from 110 V
to 240 V.
For other notes,
DC cord
7
1
of the battery pack into the
a malfunction may occur.
LCD monitor on/
Viewfinder off
45 min.
pg. 6.
29/08/00, 14:40
7
E N
2
of
LCD monitor off/
Viewfinder on
55 min.