Connection - Siemens ANT795-6DC Compact Operating Instructions

Connection

①
Screw for the horizontal alignment
②
Screw for the vertical alignment
Procedure
Note
Fix the position of the rotating bracket with the setting screws loosened.
1. Position the antenna as required.
2. First tighten the screw for the vertical axis. The tightening torque is 3.5 Nm.
3. Then tighten the screw for the horizontal axis. The tightening torque is 3.5 Nm.
4 Connection
WARNING
Danger due to lightning strikes
Antennas installed outdoors must be within the area covered by a lightning
protection system. Make sure that all conducting systems entering from outdoors
can be protected by a lightning protection potential equalization system.
When implementing your lightning protection concept, make sure you adhere to the
VDE 0182 or IEC 62305 standard.
38
Antenna ANT795-6DC
A5E03484065-02, 11/2014