EDUS121131
4.9
ON TIMER Operation
ON TIMER Operation
NOTE
In the following cases, set the timer again.
•
After a breaker has turned off.
•
After a power failure.
•
After replacing batteries in the remote controller.
Operation Manual
To use ON TIMER operation
•
Check that the clock is correct.
If not, set the clock to the present time.
1.
Press
.
"
" is displayed on the LCD.
"
" blinks.
•
"
" is no longer displayed on the LCD.
2.
Press
until the time setting reaches the
point you like.
•
Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press
again.
•
"
" and setting time are displayed on the LCD.
•
The TIMER lamp lights yellow.
Display
To cancel ON TIMER operation
Press
.
•
"
" and setting time are no longer displayed on the LCD.
•
"
" and day of the week are displayed on the LCD.
•
The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
CDXS, FDXS Series
Page 10
3
18
419