IKEA ANRATTA Manual page 7

ENGLISH
manual. Keep children away from
the installation site. After unpacking
the appliance, make sure that it has
not been damaged during transport.
In the event of problems, contact the
dealer or your nearest Aftersales
Service. Once installed, packaging
waste (plastic, styrofoam parts
etc.) must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
from the power supply before any
installation operation - risk of electric
shock.
During installation, make sure the
appliance does not damage the
power cable - risk of fire or electric
shock. Only activate the appliance
when the installation has been
completed.
Carry out all cabinet cutting
works before fitting the appliance in
the furniture and remove all wood
chips and sawdust.
Do not remove the appliance from its
polystyrene foam base until the time
of installation.
After installation, the bottom of
the appliance must no longer be
accessible - risk of burn.
Do not install the appliance
behind a decorative door - risk of
fire.
If the appliance is installed under
the worktop, do not obstruct the
minimum gap between the worktop
and the upper edge of the oven - risk
of burns.
This appliance is intended to be
used built-in.
Do not use it freestanding or place
into a cabinet.
After unpacking the appliance, make
sure that the appliance door closes
properly. In the event of problems,
contact the dealer or your nearest
After-sales Service.
ELECTRICAL WARNINGS
The rating plate is on the front
edge of the oven (visible when the
door is open).
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket in
accordance with the wiring rules and
the appliance must be earthed in
conformity with national electrical
safety standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the appliance
when you are wet or barefoot. Do
not operate this appliance if it has
a damaged power cable or plug, if
it is not working properly, or if it has
been damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualified persons
in order to avoid a hazard - risk of
electric shock.
If the power cable needs to be
replaced, contact an authorized
service center.
7