Table of Contents
Advertisement
3
B
D
nut (if
applicable)
bolt
handle knob
Fitting the Wall Bracket and Charging the Battery
G
1
H
• The battery should be
• Re-charge your cordless
1
• The cordless trimmer
All manuals and user guides at all-guides.com
Assembly Instructions cont'
C
E
2
charged for 24 hours
before use.
trimmer immediately after
every use for the full 24
hour charging period.
can be left connected to
the charger permanently,
with the charger
switched on, without
fear of overcharging.
Fitting the Handle (D & E)
1. Insert the nut into the handle knob. (if applicable)
2. Attach steady handle to product using bolt and han-
dle knob as shown in Fig D.
3. Adjust the steady handle to a comfortable operating
position, see Fig E., by unscrewing the handle knob,
springing the side lugs apart, moving the handle to
the required position, carefully re-engaging the teeth
and then tightening the handle knob.
Fitting the Shoulder Harness (F)
1. Thread the strap through the slot in the battery housing (F1).
2. Thread strap through the buckle. Adjust as required to ensure
the shoulder harness is in the most comfortable position.
F
1
• IMPORTANT !
Switch charger off at the wall socket before connecting or
disconnecting the trimmer to the wall bracket.
1. It is recommended that the wall bracket (G2) should be
mounted on a smooth, vertical and internal wall which is
strong enough to hold the weight of the product, in a well
ventilated area between 5°C and 25°C.
2. There are 3 holes on the wall bracket. Position the wall
bracket with the two holes at the top. See Fig H.
3. Ensure that when the trimmer is attached the bottom of
the trimmer is within 4 inches (100 mm) of the ground,
this will make it easier to hang the trimmer and will also
ensure that the wall bracket is within easy reach of an
electric socket to allow the charger to be plugged in.
4. Fix wall bracket securely to the wall with the plugs and
screws provided.
5. Your cordless trimmer can now be attached to the wall
bracket for charging.
Initial Charging Procedure
1. Use the charger indoors only.
2. Ensure the charger is not exposed to moisture. Keep
the charger and the trimmer dry at all times. Keep the
charger well ventilated during charging.
3. Ensure the trimmer is correctly located into the wall
bracket (G2) and the charge connector (H1).
4. Plug the charger (G1) into a suitable household electrical
wall socket and switch on.
5. The red indicator lamp glows continuously during charging.
6. Full charge will be achieved in 24 hours. During
charging the charger becomes warm. This is normal
and means the charger is operating correctly.
Re-Charging Your Cordless Trimmer
1. Re-charge the battery as soon as the cutting power of
your cordless trimmer begins to die and slow down.
2. Avoid running the cordless trimmer into "deep" dis-
charge, i.e. avoid flattening the battery completely.
3. Follow the procedure outlined in the Initial Charging
Procedure.
4. Charging the battery according to these instructions should
ensure maximum battery life.
• The charger will automatically keep the battery
topped up with charge during storage and will
ensure that the cordless trimmer is ready for use.
Advertisement
Table of Contents
