Known Issues - Solid State Logic XLogic Delta-Link MADI HD Installation And User Manual

Known issues

Start up errors
When the Pro Tools software starts up, it uses the settings defined during the previous session, e.g. number and type of Audio
®
Interfaces, I/O setup, etc.
If you have used a Legacy Audio Interface (defined through menu:
Interfaces with the Delta-Link MADI HD, the Pro Tools
was encountered". This is because the Legacy Audio Interface cannot be detected anymore. After clicking "OK", the ProTools
software will close without allowing you to change the Hardware setup!
Solution 1. (Mac or PC)
• An easy way to get around this problem is to startup ProTools
following message will eventually be displayed: "Unable to find an Audio Interface attached to..". At this point, power
up the Delta-Link MADI HD and click "OK". Pro Tools
Solution 2. (Mac Only)
• Another way to solve this problem is to delete the "DigiSetup.OSX" file and the "DAE prefs" folder in the
"Library/Preferences" folder. This will force Pro Tools
"Voices", no Hardware knowledge...)
For either solution, now go to menu:
list (see over leaf).
All manuals and user guides at all-guides.com
software will display the following error message: "DAE error -1125
®
will then continue its start up procedure.
®
®
and make sure all Legacy Interfaces are removed from the Peripherals
Setup|Hardware
), and then replaced its current Audio
Setup|Hardware
with the Delta-Link MADI HD switched OFF. The
®
to start up using a default configuration (48kHz, limited
®
21