Solid State Logic XLogic Delta-Link MADI HD Installation And User Manual page 13

1. In a typical setup, connect Primary Port A of the Delta-Link MADI HD to the Primary Port of your HD Core card and
Primary Port B of the Delta-Link MADI HD to the Primary Port of your first HD Accel card via DigiLink cables supplied.
Technically, any Primary Port of the Delta-Link MADI HD is compatible with any Primary Port of a Pro Tools
system, however, connecting Primary Ports A and B of the Delta-Link MADI HD to consecutively numbered Primary
Ports of the Pro Tools HD system is preferable in order to maintain clarity when working in the I/O Setup page of the
®
Pro Tools software.
®
Do not connect or disconnect the Delta-Link MADI HD to/from the Pro Tools
while the Pro Tools
®
require each option to be toggled on the Pro Tools I/O set up page – refer to Section 6.
2. Connect a suitable Word or Frame clock source to the WordClock input at the rear of the Delta-Link MADI HD.
(see overleaf)
3. Connect the mains cable to the mains connector of the Delta-Link MADI HD.
4. External devices may now be connected to the MADI inputs and outputs.
5. Power up the computer that hosts your Pro Tools
switch on the front panel).
All manuals and user guides at all-guides.com
WARNING!
software is running. Doing so will loose all interface settings, recovery from which will
system, and power up the Delta-Link MADI HD (using the power
®
cards or power cycle the unit
®
HD
®
9